i3D test software

Full control and easy operation

Automated test sequence in 4 steps

1. Selection of the measuring points

Create measuring points or defined measuring grids on samples or components*. The zoom of the overview camera allows a comfortable selection of measuring points. You inspect with low destruction because an impression is deep between 5 μm and 200 μm.

*These functions can be used with camera and cross table

2. Testing

After the start, the test runs fully automatically. Analogous to the hardness test, a test impression is made by a special indenter. The indentation and the surrounding throw-up are optically measured three-dimensionally.

3. Calculation

Based on the throw-up, the mechanical material properties are determined using FEM simulation results.

4. Presentation of results

The user interface displays all relevant results at a glance. The archiving of the measurement results is automated and traceable. Subsequent viewing of results and continuation of measurement series is possible at any time. The output of measurement reports, tables and diagrams is also automated at the “push of a button”.

.
Imprintec GmbH
Universitätsstraße 142 
44799 Bochum
T +49 (0) 234970414 00
F +49 (0) 234970414 09
info@imprintec.de